Specifications

40-7170 Revision 2B July 6, 2012

Bios Version 3.3c for uFlashTCP with NE2000 Ethernet

DOC Socket Services - Version 0.2

TrueFFS-BIOS -- Version 3.3.9 for DiskOnChip 2000 (V4.2)

DOS Version 3.3c for JK microsystems Flashlite

Packet driver for NE2000, version 11.4.3

This program is freely copyable; source must be available; NO WARRANTY.

See the file COPYING.DOC for details; send FAX to +1-315-268-9201 for a copy.

System: [345]86 processor, ISA bus, Two 8259s

Packet driver software interrupt is 0x60 (96)

Interrupt number 0x9 (9)

I/O port 0x300 (768)

My Ethernet address is 00:90:C2:40:43:9A

Getting Radio Node Time

No Response from Radio Node. Retrying

Got GG59351504230206

Set DOS Date/Time to Mon Dec 11 17:09:53 2006

Closed CommPort

Note: For Initial Config Type X then

UCMD UIPLINK -I00001234 –S192.168.0.101 -P7070 –N101

where -I = IPLinkID

-S = Server IPAddr

-P = Server Port

-N = Modem Number

AES UIPLink UCMD Version 0.02

RF Interference

If the IP-Link’s radio receiver is subject to RF Interference, the “RX” LED will

illuminate and remain on for more than 20 seconds. The IP-Link should not be

installed in this location until the source of the interference is cleared.

Intermittent on and off of the RX LED is normal operation.

Example 1: Startup Messages (After a Board Reset and pressing X)

Editing files:

You will have to edit file(s) to configure this device to communicate with its assigned

MultiNet Receiver. To edit a file, at the “C:\>” prompt key in “edit {filename}<Enter>”.

{filename} is replaced with the actual name of the file to view or edit.

The following commands are used within the DOS Line Editor:

Enter the number of a line and press enter to edit that specific line.

i: for insert “Use this command only and only if a line of the file was missing”

l: for list all the lines of the file.

d: for delete “Use this command if you typed the wrong info into the file”

s: for save after you’re done changing the file you must save.

Q: for quit to exit the file