Specifications

40-7170 Revision 2B July 6, 2012
19
Figure N – HyperTerminal - COM Properties
6. You are now ready to use HyperTerminal.
Figure O – HyperTerminal
A.2. Optionally, Configure Telix (in DOS) to communicate with the 7170:
1. Locate and start the Telix program. Example: (assuming Telex.exe is in C:\Telix)
CD\Telix<Enter> then Telix<Enter>.
2. Pres <Alt> P to bring up the Com Parameters window.
3. Change communication parameters to 19200,N,8,1,COM<X> where COM<X> is
the COM port you are connected to. Press <F> then <O> to set communication
parameters. Press the number corresponding to the COM Port then press <Enter>
to set Com port and exit parameters window.