Specifications

40-7170 Revision 2B July 6, 2012
13
Figure K. RF Control Board, Input terminal Block
Figure I. Power Connector
B. Terminal Block Connection Details:
The terminal designations for the Power
Connector terminal block are shown in the
diagram to the right. Connect your 16.5 VAC
transformer to the designated terminals.
DO NOT apply power to these until the
MultiNet Receiver is set up and you are
ready to proceed with configuration of this
Unit.
The terminal designations for the Telephone
(TELCO) Connector terminal block are shown
in the diagram to the right. These terminals
should be properly connected to an RJ-31X
phone jack to allow for proper line seizer
functions. Refer to telephone company
documentation. T and R are to Tip and Ring of
phone line. T1 and R1 are for Tip and Ring to
premise telephones, if any.
UL Installation Note: When connecting the 7170 IP-Link Transceiver’s modem to a
telephone line, a UL Listed 497A Secondary Protector is required to be installed on the
incoming lines. Installation shall be in accordance with the NEC Article 800, the
manufactures installation instructions and in accordance with all local codes.
Figure J. Telephone Connection
The terminal designations for the RF / Radio Controller Board Connector terminal block are
shown in the diagram above. Use only UL listed 26AWG minimum wire.
The factory installed Enclosure Tamper Switch is connected to terminals (-) and Z4 as shown.
DO NOT USE, Z1, Z3, AND Z5 THRU Z8 as indicated on label.