Product Manual

No. 1200 - 08/15
CLEAR MARKING COAT
PRODUCT NUMBERS: 200 CLEAR
I. GENERAL DESCRIPTION
Description: This durable, clear coating is used to seal
and protect construction chalk lines and other temporary
marks from wind, moisture, and trafc. It is packaged
in a can that can only be operated in an upside down
position.
Benets: Aervoe Clear Coat will protect and increase
the color fastness of all marking and striping paints, and
other painted coatings. Once dry, it is not affected by
moisture or water, and will not wash away.
Uses: It is designed to adhere to most surfaces, including
pavement, gravel, and soil. It can be used to protect any
chalk or temporary markings at construction sites or utility
identication projects.
Application: Shake can well before use and for 1 to 2
minutes after agitator ball is heard. Remove tab from
tamper-resistant cap. With proper alignment of the
activator bar, this product can be used with the cap on in
Aervoe applicators #244/245. Apply paint 3 to 4 inches
from surface by hand or 5 to 8 inches in the applicator
for a ¾-inch line or continuous directional mark. Keep
can in motion during use to prevent puddling. Agitate can
periodically during application. Clear paint from valve and
tip after each use by turning can in an upright position
and spraying for 3 to 5 seconds. For best results, use at
temperatures between 60°F and 80°F (16°C to 27°C).
Limitations: Please refer to the Safety Data
Sheet for specific information on material hazards,
etc. This aerosol product is designed to spray
at an angle not greater than 30° from vertical. Do not
use on turf surfaces.
Packaging:
Aerosol: Cans (211x713) 15 oz. net wt. (425 g) 5.3 . oz. (157 ml)
12 cans/case 16 lbs. (7.25 kg) 0.55 CF (0.016 CM)
Product Data Sheet
Aervoe Industries, Inc.
P.O. Box 485, Gardnerville, NV 89410
[phone] Phone • [phone] Fax • [phone] Customer Service
www.aervoe.com • [e-mail]
Aerosol MIR 1.20 VOC<66^ - Ground Trafc Marking