Product Manual

No. 11420 - 08/18
FADE-OUT MARKER
PRODUCT NUMBERS: 1420 FLUORESCENT RED
1422 FLUORESCENT ORANGE
I. GENERAL DESCRIPTION
Description: A unique, UV sensitive marker designed
in direct response to community concerns to minimize
unsightly marks in visually sensitive areas, long after
construction and surveys are completed. With its patented
formula (#6,652,638), Color progressively fades to clear
in 30 to 35 days, depending on direct sun exposure and
trafc. It is designed to be operated only in an upside
down position.
Benets: Ideal for use in visually sensitive areas. Marks
progressively fade over a 30 to 35 day period to a clear,
opaque mark. Can be used with the cap on in the Aervoe
#244 Spot Marker or #245 Marking Stick. The spray-
through cap eliminates accidental discharge. Each can
is non-clogging and empties completely.
Uses: Will mark and adhere to most surfaces, including
asphalt, concrete, gravel, and wood. It is ideal for utility
identication on private property, but can also be used for
marking at construction sites, and other general marking
requirements where short term identication is desired. It
is not recommended for use on turf surfaces.
Application: Shake can for 1 to 2 minutes after rattle
of the agitator ball is heard. Remove safety tab, invert
can, and apply 3 to 4 inches from the surface for writing
symbols and numbers. Apply 5 to 8 inches from the
surface for 3/4" line or continuous direction tracks.
Keep can in motion during use to prevent puddling due
to high delivery paint stream. For best results, use at
temperatures between 60° and 80°F (16° and 27°C). If
cap has been removed, replace it for storage and color
identication. Clear spray tip after each use by turning
can upright and spraying for 2 to 3 seconds.
Limitations: Please refer to the Safety Data Sheet for
specic information on material hazards, etc. This aerosol
product is designed to spray upside down or at an angle
not greater than 30° from vertical. Use caution if surface
is wet, or if rain is imminent within 1 hour of application.
Do not apply additional product until the previous coat is
dry. On fresh asphalt or other porous surfaces, removal
may be hampered due to solvent/pigment penetration.
Packaging:
Aerosol: Cans (20 oz.) 15 oz. net wt. (425 g) 20.2 . oz. (597mL)
12 cans/case 16 lbs. (7.3 kg) 0.55 CF (0.016 CM)
Product Data Sheet
Aervoe Industries, Inc.
P.O. Box 485, Gardnerville, NV 89410
[phone] Phone • [phone] Fax • [phone] Customer Service
www.aervoe.com • [e-mail]
Ground Trafc/Marking Coatings; Aerosol VOC <66%, CARB MIR <0.85