User manual

Aerosoft Wilga X 1.00 Manual
Page 10 of 21
 Magneto switch to 1+2
 Starter switch to on for 2 seconds
 After engine starts:
Establish 900-1000 RPM
Check oil pressure reaches 1,5 Kg/c -> if not stop engine
WARMING UP
 Maintain 900-1000 RPM until oil temperature starts to rise then
 Slowly raise RPM in one minute steps ( 1200, 1400, 1600, 1800 and finally 2000 RPM) until cylinder
head temperature is at least 120 C° and Oil Temperature is at least 30C°
 After engine is warmed up check the propeller controls (fully travel) to ensure it works and is warmed
up
To stop the engine:
 Run engine at 1900-200 RPM for 30 seconds to clean the plugs
 Reduce RPM to 600-700
 Magneto switch to off
 Throttle smoothly to full open
 When engine is stopped:
o Throttle back to idle
o Fuel selector closed
o Switches off