Aerosoft Wilga X 1.00 Manual INTRODUCTION The PZL-104 was developed by the Development Design Office of the PZL factory (Poland). It was designed to be a sturdy and simple aircraft able to operate from small unpaved runways. The high wing has additional lift surfaces so it is a real STOL (Short Take-Off and Landing) aircraft that can fly at very low speeds and has very gentle stall characteristics. The pilot and navigator were placed next to each other to make communication easier.
Aerosoft Wilga X 1.
Aerosoft Wilga X 1.00 Manual INSTALLING After downloading the file unzip and start the setup.exe file. At the end of the installer the Aerosoft Launcher tool will be installed. This allows you to register the product and get easy access to the manuals, updates etc. Appendix A has more information on this. REMOVING THE AIRCRAFT FROM YOUR SYSTEM Never remove the product manually, always used the control panel applet to do so. Failing to do so could create serious problems.
Aerosoft Wilga X 1.00 Manual CONSTRUCTION The PZL-104 I has a high mounted wing that includes slot flap drooped aileron and fixed wing slats. The fuselage is made up from a semi-monocoque metal frame with partially fabric covered panels. The power plant consists of the redial reciprocating air-cooled engine АI-14RA with two-blade rotor controllable pitch US 122000. The twin fuel tanks are in the wings.
Aerosoft Wilga X 1.00 Manual THRUST RATINGS Pressure kp/cm² Thrust Rating Temperature°C RPM Fuel Consl/h Manifold Fuel Oil Engine Oil Take-off Power 2350 ±1% 35 ±10% 0.2<>0.5 4<>6 120<>230 30<>75 80-85 Rate Power 2050 ±1% 30 ±10% 0.2<>0.5 4<>6 120<>230 30<>75 70-75 Cruise Rating I 1860 ±1% 680 ±15% 0.2<>0.5 4<>6 120<>230 30<>75 60-65 Cruise Rating II 1730 ±1% 630 ±15% 0.2<>0.5 4<>6 120<>230 30<>75 55-60 Idle <500 >0.15 >1.
Aerosoft Wilga X 1.00 Manual AIRCRAFT SYSTEMS OIL SYSTEM The oil system is used for lubrication, cooling and is used by the propeller control mechanism. It consists of oil tank, oil filter, oil cooler (with a louvers air flow control mechanism controlled by a turn knob in the cockpit), engine driven oil pump and a cockpit indication for the oil pressure and oil temperature. Proper use of the oil cooler is important and oil temperature should be monitored closely.
Aerosoft Wilga X 1.00 Manual PANELS MAIN PANEL 1. Airspeed indicator 2. Altimeter 3. Directional gyro 4. Attitude indicator 5. Alternator caution lamp 6. ADF indicator 7. Climb indicator 8. Clock 9. Magnetic compass 10. Oil temperature, oil pressure and fuel pressure indicator 11. Manifold indicator 12. Mixture temperature indicator 13. Engine temperature indicator 14. Tachometer 15. ADF (АРК-9) 16. “Distance/Narrow” switch 17. Start button 18. Magneto switch 19.
Aerosoft Wilga X 1.00 Manual OVERHEAD PANEL 1. 2. 3. 4. 5. 6. Battery switch Alternator switch Ignition switch Oil pressure indicator switch Fuel pressure indicator switch Mixture temperature indicator switch 7. Pitot heat switch 8. Cabin light switch 9. Dome light switch 10. Devices light switch 11. Nav-lights switch 12. Directional gyro switch 13. Attitude indicator switch 14. Radio switch 15. Wiper blade switch 16. Excess-voltage protection switch 17. Alternator protection switch 18.
Aerosoft Wilga X 1.
Aerosoft Wilga X 1.
Aerosoft Wilga X 1.
Aerosoft Wilga X 1.00 Manual CLIMB Standard climbs: o 2050 rpm o 30 kp/cm² manifold pressure o 120 km/h o Cylinder head temperature not over 240 °C o Oil temperature not over 85 °C 85 °C is allowed for not more than 15 minutes, then reduce to 50-60 °C o Oil pressure 4 - 6 kp/cm² o Fuel pressure 0.2 - 0.
Aerosoft Wilga X 1.00 Manual o Cylinder head temperature : 140 °C o Oil temperature : 30 °C o Inlet temperature : 10 °C When temperatures drop below these values, increase power.
Aerosoft Wilga X 1.
Aerosoft Wilga X 1.00 Manual APPENDIX A: AEROSOFT LAUNCHER The new installer and launcher system has advantages for Aerosoft (it protects our copyrights better) and for the customers (makes it easier to see what is installed and what updates are available. Using the new system is simple and only adds a few steps to what was used before. There are however four things that you have to keep in mind.
Aerosoft Wilga X 1.00 Manual Now you have to accept the license agreement. Easy to click [I accept....] but you might like to read the text at least once, okay? Enter your email address and the serial code we have sent you.
Aerosoft Wilga X 1.00 Manual A few screens that tell you what will happen. Click [Next] unless you see an obvious issue. One more...
Aerosoft Wilga X 1.00 Manual The files are now installed. Will take a few seconds. And you're done. Click [Finish] to close the installation part of getting the software in FSX. Now Aerosoft Launcher will start and you will see this.
Aerosoft Wilga X 1.00 Manual Click on the [Sceneries] to open that section of the product tree. And there is the product we have just installed. By clicking on the [Activate] button the launcher will activate the software.
Aerosoft Wilga X 1.00 Manual Select the download shop you used, enter the email address used when buying and the serial code and click [Online activation]. You will see the program contact the server and do its work. Note that only appropriate information is sent. Product code, email address etc. Eh voila, the product shows in green and you can now start FS to start enjoying the product.
