General Guidelines

Aerosoft
Twin Otter EXTENDED
The Twin Otter Extended In FSX
Vol
1
1-1-4
19 November
2013
INSTALLATION AND REMOVAL
Installation is simple-- start the .exe file you downloaded and follow the instructions on screen. Make sure
FSX (P3D) is closed and we do advise you to reboot your system before installing. After installing it can help
to defragment your hard disk (unless it is a SSD drive that should not be defragmented)
Removal should never be done manually but only using the software removal applet you will find in the
Windows Control panel.
CHECKLIST
The Aerosoft Twin Otter Extended comes with a very clever checklist system. Not only does it show you all
the steps you need to perform, it will even do it for you when asked. Because it is not always easy to know
where the instrument is located you need to check, the viewpoint will change automatically!
USING THE CHECKLIST
If you left click the first item on a checklist (for example [ ] CONTROL LOCKS on the Pre-Start checklist) you
will either see a red x or a green v. Red means the action has not been done and green that this item is
checked and okay. If it is red you have two options, either manually do the action or right-click the item to
have the checklist perform the action for you. Doing that you can go from a cold and dark aircraft to one
ready for take-off by just right clicking checklist items!
Do note you have to click on the [ ] section of the checklist item to check or set it. If you click on the text
behind it the view will be set to the right panel. If you click on the checklist title, it will reset that section of
the checklist.