User manual

Table Of Contents

Piper PA-31T Cheyenne X

Aerosoft GmbH 2007

76 77

Direct Tune Mode

The Direct Tune Mode is entered by pressing and holding the transfer

button for longer than two seconds. The „STBY” frequency will disap-

pear and the frequency in the active window can be changed with the

frequency selection knobs. Momentarily pushing the transfer button

will return the unit to the Frequency Mode (normal operation). The

„STBY” frequency displayed prior to entering the Direct Tune Mode

will return unchanged.

KY 53 TSO´d Navigation Receiver Operation

Power Switch

This knob controls ON/OFF function for the KY53. Volume selection

and IDENT function are not modeled.

Frequency Selection

By rotating the concentric frequency selector knobs either clockwise

or counterclockwise, the desired operating frequency can be dialed

into the standby display window. A clockwise rotation will increase

the displayed frequency number, while a counterclockwise rotation

will decrease it. The larger selector knob is used to change the MHz

portion of the frequency display; the smaller knob changes the kHz

portion in 50 kHz steps. At either band edge of the 108.00 to 117.95

MHz frequency spectrum, an off-scale rotation will wrap the display

around to the other frequency band-edge (i.e., 117.95 advances to