User manual

Table Of Contents

Piper PA-31T Cheyenne X

Aerosoft GmbH 2007

74 75

Press the transfer button to activate the new frequency. The

newly entered frequency in the „STBY” window ﬂipﬂops with

the frequency in the „USE” window. This new frequency is

now available for use.

Program Mode

The Program Mode is used to program frequencies for use in the

Channel Mode.

Depress the channel (CHAN) button for more than two

seconds, until the channel number (to the right of the standby

frequency) begins ﬂashing. The most recently used active

frequency will remain displayed in the „USE” window.

Turning either frequency selection knob will change the channel.

Once you’ve selected the desired channel number, you may

program a new frequency by pressing the transfer button. This

will cause the frequency in the „STBY” window to ﬂash. The

tuning knobs are now used to enter desired frequency.

To program additional channels, push the transfer button

again to make the channel number ﬂash, and repeat step three

above.

If you wish to program fewer than nine channels while skip-

ping certain channel numbers, rotate the MHZ frequency knob

left or right beyond 136MHz or 118MHz. Dashes (---) will

appear in the „STBY” window, indicating that the channel will

be skipped when the system is operating in the Channel Mode.

To exit the Program Mode, momentarily press the channel

button. The unit will also automatically exit the Program Mode

if no programming occurs within approximately 20 seconds.