User manual

Piper PA-31T Cheyenne X
Aerosoft GmbH 2007
66 67
66 67
tomatic Glideslope capture is „locked out” by the switching circuitry.
Localizer deviation on HSI will have the proper sensing if the front
inbound Localizer course was set on the HSI.
Special note: Back course mode is only available after selecting APPR
mode.
GO-AROUND Mode
The Go-Around mode is primarily designed to assist the pilot in establi-
shing the proper pitch attitude under missed approach conditions. The
Go-Around switch is located on the autopilot panel in the upper left
corner in form of a hidden click spot.
Activating the Go-Around mode during an approach cancels all Flight
Director modes and disengages the Autopilot, if it is engaged. A
wings-level and pitch-up command is displayed by the FCI and „GO
AROUND” is lighted on the Annunciator Panel. The magnitude of the
pitch-up command is adjustable to match Flight Manual criteria for
each aircraft model.
The Go-Around mode may also be used on takeoff for climb-out
attitude guidance. When used for takeoff, the Go-Around mode may
be followed with HDG for continuous heading control during departure.
NAV and APPR modes may also be armed for automatic capture
and guidance during the departure sequence. Go-Around may be
cancelled by use of Vertical Trim, Altitude Hold mode, Control Wheel
Steering mode or by turning off the Flight Director.