User manual
Table Of Contents
- PBY Catalina
- Introduction
- System requirements
- Credits
- Copyrights
- Contact support
- Models and versions
- Limitations
- Failure model and special features
- Aerosoft Sound Control
- Flight model
- Using the switches and knobs
- Interactive Checklist
- Avionics, 1940’s military cockpit
- Avionics, modern cockpit
- Engine Settings
- Mission
- Appendix A: Simplified checklist
- Appendix B: KX 165A TSO
- Appendix C: KLN-90B User Manual
- INTRODUCTION
- OVERVIEW
- DEFINITIONS:
- SYSTEM USE
- NAV: NAVIGATION PAGES
- CALC: CALCULATOR PAGES
- STAT: STATUS PAGES
- SETUP: SETUP PAGES
- OTHER: OTHER PAGES
- TRIP: TRIP PLANNING PAGES
- MOD: MODE PAGES
- FPL: FLIGHT PLAN PAGE
- NAV: NAVIGATION PAGES (right screen)
- APT: AIRPORT PAGES
- NEAREST Airport Pages
- VOR: VOR Page
- NDB: NDB Page
- INT: INTERSECTION PAGE
- SUPL: SUPPLEMENTAL PAGE (SUP)
- CTR: CENTER WAYPOINT PAGE
- REF: REFERENCE WAYPOINT PAGE
- ACTV: ACTIVE WAYPOINT PAGE (ACT)
- D/T: DISTANCE/TIME PAGES
- MESSAGE PAGE
- DIRECT-TO PAGE
Aerosoft PBY Catalina 1.00 Manual
Page 96 of 100
D/T PAGE 3 WITH FLP 0:
Fig15.6
The format displayed on the D/T 3 page when the FPL 0 page is open simultaneously on the left
screen is shown in Fig15.6. The distance and ETA information on the D/T 3 page is listed in order of
the distance to the destination waypoint, and corresponds to the order displayed on the FPL 0 page.
The first line on the D/T 3 page with distance and bearing information will always correspond to the
next active waypoint leg and will be indicated by the arrow on the FPL 0 page; as you pass a
waypoint leg, the corresponding information displayed on the D/T 3 page will disappear. There are 2
columns of information.
• Left Column: Displays the distance to the corresponding waypoint of the flight plan in nm.
• Right Column: Displays the bearing to the corresponding waypoint of the flight plan in
degrees magnetic north.
D/T 4: Distance/Time 4 Page (D/T 4)
Fig 15.7
The D/T 4 page displays time information regarding the entire flight to the destination waypoint.
This includes the time when departing the initial airport, the local time, the flight time, the
estimated time enroute to the destination waypoint, and the time of arrival at the destination
waypoint. The time format is hrs:mins. There are 6 lines of information.
• Line 1: The left side of line 1 displays the destination waypoint identifier. The right