User manual
Table Of Contents
- PBY Catalina
- Introduction
- System requirements
- Credits
- Copyrights
- Contact support
- Models and versions
- Limitations
- Failure model and special features
- Aerosoft Sound Control
- Flight model
- Using the switches and knobs
- Interactive Checklist
- Avionics, 1940’s military cockpit
- Avionics, modern cockpit
- Engine Settings
- Mission
- Appendix A: Simplified checklist
- Appendix B: KX 165A TSO
- Appendix C: KLN-90B User Manual
- INTRODUCTION
- OVERVIEW
- DEFINITIONS:
- SYSTEM USE
- NAV: NAVIGATION PAGES
- CALC: CALCULATOR PAGES
- STAT: STATUS PAGES
- SETUP: SETUP PAGES
- OTHER: OTHER PAGES
- TRIP: TRIP PLANNING PAGES
- MOD: MODE PAGES
- FPL: FLIGHT PLAN PAGE
- NAV: NAVIGATION PAGES (right screen)
- APT: AIRPORT PAGES
- NEAREST Airport Pages
- VOR: VOR Page
- NDB: NDB Page
- INT: INTERSECTION PAGE
- SUPL: SUPPLEMENTAL PAGE (SUP)
- CTR: CENTER WAYPOINT PAGE
- REF: REFERENCE WAYPOINT PAGE
- ACTV: ACTIVE WAYPOINT PAGE (ACT)
- D/T: DISTANCE/TIME PAGES
- MESSAGE PAGE
- DIRECT-TO PAGE
Aerosoft PBY Catalina 1.00 Manual
Page 81 of 100
APT 5: Airport 5 Page (APT 5)
Fig 8.6
The airport 5 page is currently UNAVAILABLE.
APT 6: Airport 6 Page (APT 6)
Fig 8.7
The airport 6 page is used to display the fuel services available at a user-selected airport. The lines of
information depend on the available fuel services.
• Line 1: Displays the user selected airport ICAO identifier code.
• Lines 2-: Displays the available fuel services.
To use this airport page:
1. Display the APT 6 page on the left screen. Click the RIGHT INNER KNOB to the in position.
2. Click on the RIGHT CURSOR BUTTON and a blinking rectangle will appear behind the airport
ICAO (or "----") on Line 1.
3. Click on the right side of the RIGHT INNER KNOB (Letter H) to activate data entry. A blinking
rectangle will now be present behind the first digit of the airport ICAO identifier.
4. Use the RIGHT INNER KNOB, or keyboard, to enter the desired ICAO code.
5. Click the ENTER BUTTON twice to exit data entry and go back to the default screen.
6. Clicking on the CLR BUTTON at any time will exit the data entry mode without entering any
newly added data.