User manual
Table Of Contents
- PBY Catalina
- Introduction
- System requirements
- Credits
- Copyrights
- Contact support
- Models and versions
- Limitations
- Failure model and special features
- Aerosoft Sound Control
- Flight model
- Using the switches and knobs
- Interactive Checklist
- Avionics, 1940’s military cockpit
- Avionics, modern cockpit
- Engine Settings
- Mission
- Appendix A: Simplified checklist
- Appendix B: KX 165A TSO
- Appendix C: KLN-90B User Manual
- INTRODUCTION
- OVERVIEW
- DEFINITIONS:
- SYSTEM USE
- NAV: NAVIGATION PAGES
- CALC: CALCULATOR PAGES
- STAT: STATUS PAGES
- SETUP: SETUP PAGES
- OTHER: OTHER PAGES
- TRIP: TRIP PLANNING PAGES
- MOD: MODE PAGES
- FPL: FLIGHT PLAN PAGE
- NAV: NAVIGATION PAGES (right screen)
- APT: AIRPORT PAGES
- NEAREST Airport Pages
- VOR: VOR Page
- NDB: NDB Page
- INT: INTERSECTION PAGE
- SUPL: SUPPLEMENTAL PAGE (SUP)
- CTR: CENTER WAYPOINT PAGE
- REF: REFERENCE WAYPOINT PAGE
- ACTV: ACTIVE WAYPOINT PAGE (ACT)
- D/T: DISTANCE/TIME PAGES
- MESSAGE PAGE
- DIRECT-TO PAGE
Aerosoft PBY Catalina 1.00 Manual
Page 55 of 100
CALC 5: Calculator 5 Page (CAL 5)
Fig2.5
The calculator 5 page is used to convert degrees Celsius to Fahrenheit and vice versa, and to convert
between nautical and statute miles per hour. There are 5 lines of information.
• Line 1: Display to indicate the page is used for temperature and speed conversions.
• Line 2: Display of the user-entered or corresponding Fahrenheit temperature in degrees
Celsius.
• Line 3: Display of the user-entered or corresponding Celsius temperature in degrees
Fahrenheit.
• Line 4: Display of the user-entered or corresponding mph speed in nautical miles per hour.
• Line 5: Display of the user-entered or corresponding nm per hour speed in statute miles per
hour.
To use this calculator page:
1. Display the CAL 5 page on the left screen and click on the LEFT CURSOR BUTTON.
2. Use the LEFT OUTER KNOB to scroll through data entry fields, and the LEFT
3. INNER KNOB to change the values. Each data entry field is highlighted with a background
rectangle to show the current field to be changed. All values will be computed as you enter
the data.
4. Exit the data entry mode at any time by clicking on the LEFT CURSOR BUTTON. All data
entered in the session will be retained.