User manual

Section Part B
28 STARTER ENGAGED WARNING LIGHT ON
After engine start, should the starter relay remain engaged the starter will remain
energised. The Starter Engaged Warning Light will remain illuminated indicating that
damage will occur to the starter system and/or electrical system should the situation
persist.
Starter Switch
Mixture
Ignition
Battery Master Switch
Ensure Off
Idie Cut-off
Off
Off
Investigate fault and do not attempt a restart until fault rectified
29 EMERGENCY FLOAT OPERATION
WARNING: Before starting manual float operation place operating switches on yoke to
"OFF", and isolate the float electrical system by turning the float power switch to "OFF" at
the Main Distribution Panel.
If the electrical system fails the floats may be operated manually:
EMERGENCY FLOAT OPERATION DIAGRAM
To lower floats
1 .
1 Remove the crank handle from the buikhead in the Galley.
2 Engage crank in "FAST" socket and crank anti clockwise.
3 Visual check and crank load will show that the floats are down.
The throttle check below 15" will confirm the latching of
the down lock.
4 Remove and re-stow crank handje
To raise floats
1 Insert crank in "FAST" socket and crank clockwise until load gets
too heavy. Transfer to "SLOW" socket and continue until floats
are up.
2 Remove and re-stow crank handle
Rev No: 00 Stichting Catalina PH-PBY
Page: 24 18 May, 2004