User manual

Table Of Contents
Part B Section 2.2
Stichting Catalina PH-PBY Rev No: 01
25 May, 2005 Page: 3
Cockpit Preparation
Circuit Breakers............................................................................... Check
Check if the circuit breakers on the box situated left of the PF, the instrument panel, the
emergency shut off panel and on the electric panel are all in
Hull and Float Drain Plugs............................................................... Check
Check if the plugs are all in and box is empty and on board
Clamps............................................................................................. On Board
Check two clamps on board
Gear locks and pin………………………………………………………….On Board
Check three gear locks and the nosegearpin on board.
Fasten Seat Belts and No Smoking................................................ On
Emergency Shut Off Valves............................................................ Open
Check the two guards are closed
Throttles........................................................................................... Cracked
Open throttles appr. ¼ inch
Prop Levers...................................................................................... Full Fine
Check prop levers fully forward
Mixtures........................................................................................... I.C.O.
Check mixture levers are in idle-cut-off position
Master Magneto............................................................................... In
Check master magneto switch is pushed in
Magneto Switches............................................................................ Off
Check both magneto switches are in the off position
Fuel Quantities................................................................................. . . . .Gals/Hr
Mention amount of Gallons and Endurance
Oil Quantities...............................................................................… . . . .Gals/Hr
Mention amount of Gallons and Endurance
Altimeters......................................................................................... . . . .Set
Check both altimeters are set to current QNH value