User manual

Menorca X Evolution
Aerosoft GmbH 2016
20 21
English
Textures Display Setting
Please set the resolution for Global Texture to very high. Otherwise the
building textures will be displayed at a lower resolution.
FSX DX10 Preview
This scenery is FSX DX10 compatible, despite the safegate models: If
you are using the DX10 preview mode without any „DX10 fixer“ the
safegates will be displayed in grey. There is no known way to build
safegates or other docking and guidance systems for DX10 preview
mode. If you use the DX10 fixer (https://stevesfsxanalysis.wordpress.
com/), which we recommend due to other „DX10 out of the box“
errors and limitations, everything should be fine (The freeware DX10
fixer will not cure the texture poblem. You need the 2.7 or higher
payware version).
Use of the airports without the Island´s textures
Some users asked if they could use the airports without using the
photographic island textures. Well now it is possible, but we don´t
recommend it.
If you want to remove the island´s textures, you have to remove the
following files from /LEPA_FSX_EVO_TERRAIN/SCENERY:cvxEXCLUDE
MALLORCAROADSUT.bgl, cvxEXCLUDEMALLORCASTREAMSUT.bgl,
cvxLEPA_EXCL_SHORE.bgl, cvxLEPA_WASSER_ALL.bgl, cvxLEPA_WAS-
SER_ ALL2.bgl, cvxLEPA_WASSER_ALL3.bgl, cvxLEPA_WASSER_ALL4.
bgl, mallemitte.bgl, mallenord.bgl, mallesouth.bgl.
At /LEPA_FSX_EVO_TERRAIN/TEXTURE remove all *.agn files. The
aerials of the airports will remain, but they will not have any seasonal
textures.
Up to date approaches in the AFCAD for correct
display and approach selection in the ATC
The approach procedures in the AFCAD of this scenery are based on
the current AIRAC Cycles of the time of release of this scenery as the
approaches included in the simulator are very outdated. We´ve
included the VORDME, ILS, NDB and LOC procedures available for
each runway, including the IF (Initial Fix) for direct and STAR approach-
es.
You can now request the correct Initial Fix from the flight sim ATC
during your flight when transitioning from en-route to approach.
Additionally, you can select and display these approaches if you use
the default Garmin system.
Unfortunately the list of approaches in the ATC window of the FS ATC
is limited. When you select ILS as Initial Fix, it only shows VOR and
NDB navaids, but no waypoints. You will have to use GPS or RNAV,
where all types of IFs are available, including waypoints.
The FS ATC also doesn’t allow for prefixed designations, e.g. ILS-Z or
ILS-Y; therefore, ILS-Y is implemented as GPS and ILS-Z as RNAV.