User manual

32 33

The selected calibration point will now be added to a table of points,

just below the data entry area. You will see him with his relative position

(in pixels) inside your map. The ﬁelds for the geographical coordinates

are still empty. You may now enter these directly, or indicate the position

to be a navaid. In our case, our calibration point is located at the position

of the SS (Sturup) NDB in Sweden, near Malmoe.

In case you don’t know the exact coordinates of your calibration point,

you may use the Flight Simulator navigation database as a reference.

If you enter the code for the navaid in either the latitude or longitude

ﬁeld, FSMap will retrieve the correct coordinates, and use them. Please

note that these coordinates may differ from the exact position on the

chart, as the database may contain errors. In case you’ve selected a

code which exists in the database more than once, a selection dialog

will appear to allow you to select the right navigation aid.

Now deﬁne the upper left and lower right corners. Zoom into the

upper left corner, right-click with your mouse, and select „Set Top/Left

Corner“ from the popup menu. In the same way, select the lower right

border by choosing „Set Bottom/Right Corner“ at the appropriate

map position.