User manual
FDC Live Cockpit! 2011
Aerosoft GmbH 2010
84
•Finally,youshouldenterthemaximumcruisespeedforthe
737. Enter 0.76 in the Mach text box, leaving the knots text box
unchanged at ‘0’. Alternatively, you could have entered the speed
in knots, leaving the Mach speed unchanged at ‘0’.
contains a table of weight and speed data for the available flap
settings of the aircraft. The columns of the landing data table are
explained below.
Weight The weight of the aircraft
FDC Live Cockpit! 2011 uses this weight to decide which speed data
to use. The given row is used for all weights higher than the entered
weight, up to the next (higher) weight (as for takeoff data). If you
enter ‘0’, the row will be used for all weights up to the next entered
weight.
Weight x 1000 lbs.
(131 equals a weight of 131,000 lbs)
Required:Yes
F1 - F40 The speed at which to make flap call
The speed at which the corresponding flap call should be made. As
an example, if you enter 100 in the F5 column (if it exists for your
aircraft), the Flap 5 call will be made just before the speed of the
aircraft reaches 100 knots. There is one column for each flap position
selected for the aircraft. The values should decrease from left to right
(higher speed for less flap detente).
Note! If you don’t want a call to made for a flap setting during
landing, you can enter ‘000’ in the corresponding column.
Speed in knots
F0 > F1 > F2 > ... > F40
’000‘ disables given call
Required:No