User manual

Aerosoft F-16 Fighting Falcon 1.00 Manual
Page 31 of 46
AIR CONDITIONING
AIR SOURCE Controls the pressurization of the cockpit and fuel tanks. Use left and right mouse
key to operate.
OFF - engine bleed air valves closed, no pressurization of any system (neither cockpit,
neither fuel tank)
NORM - standard setting during flight, will keep cockpit pressurized and regulates
temperature
DUMP - operates cockpit pressure dump valve to make cockpit pressure equal to
outside pressure, is needed to open the cockpit
RAM - engine bleed valves close, all cooling and pressurization systems off, ram air valve
open allows ram air to ventilate cockpit and avionics.
TEMP - Allows you to set a comfortable temperature.
AVIONICS POWER panel
The AVIONICS POWER holds the most important controls for the avionic systems. After you got
electrics to the busses you need to set these switches to activate the main displays.
INS SWITCH
OFF - Deactivate INS
CAL -This will initiate, calibrate and automatically switch to NORM after 6 minutes
when lat/lon is feed to DED
IN FLT ALIGN - This will initiate a 1 minute calibration process
NORM - Will immediate get lat/lon (default position in flight)
MFD - toggles MFDs on/off
UFC - toggles DED on/off
GPS - toggles internal GPS receiver
ST STA - toggles FSX NAV mode (GPS/NAV)
MMC - dummy
DL - dummy
HUD REMOTE CONTROL PANEL
The HUD remote control panel determines what is shown on the HUD. Note there are two
versions of this panel, depending on the model.
VY VYH / VAH / OFF
VY/VAH - display vertical velocity, velocity, altitude, heading plus Bank Angle Indicator
VAH - display velocity, altitude and heading
OFF - heading, velocity and altitude scales only as digital readouts
ATT / FPM / FPM / OFF
ATM/FPM - display the Flight Path Marker and the Pitch Ladder
FPM - display the Flight Path Marker
OFF - no Flight Path Marker and Pitch Ladder
DED DATA / PFL / OFF
DED DATA - displays DED data in the HUD
PFL -displays Pilot Fault List data (only in block 40/42 current, 50/52)
OFF - does not display DED data or Fault Lists data
CAS / TAS / GND SPD