User manual

Aerosoft F-16 Fighting Falcon 1.00 Manual
Page 24 of 46
AUX COMS PANEL
We implemented only the channel setting and linked to the Transponder in FSX. Click with the left
mouse to set the transponder codes. Some important military routine codes:
0001 - High speed uncontrolled flight
4000 - FR Military training
7001 - Sudden climb out of low level military VFR (UK only)
7777 - Military intercept
CANOPY CONTROLS
The canopy is opened with a small switch above the Left
Console. The switch is locked with the “Octopus” that also
serves as a secondary securing latch. To open the canopy move
the octopus up and click the switch beneath it. To close and lock the
canopy, click the switch and lock with the octopus. In flight the
Octopus always needs to be down. On the C models the Canopy
Switch is located more to the back, over the ECU panel. The Canopy
Jettison Handle and the Manual Canopy Control are inop.
ELECTRONIC
This panel contains the main power switch that determines if the aircraft systems run from any of
the electrical sources: Battery, Main Generator, Standby Generator or Emergency Power Unit. The
status lights show possible problems.
MAIN POWER
MAIN POWER - connects the engine generator to the system bus and battery to the battery bus
BATT - connects the battery to the system bus and battery bus, disconnects generator
OFF - Disconnects generator from aircraft systems
STATUS LIGHTS
FLCS PMG - FLCS not getting power
MAIN GEN - Main generator online or offline
STBY GEN - Standby Generator online or offline
EPU GEN - EPU on but not supplying power to essential busses
EPU PMG - - EPU on but not supplying power to all sections of FLCS
TO FLCS - Flight Control System no or low voltage
FLCD RLY - Flight Control System no or low voltage
FAIL - Aircraft battery failure
CAUTION RESET - inop
ENG START PANEL
The ignition panel is used to start the engine.
ENG CONT - Toggles automatic Ignition
JET FUEL STARTER - Starts the hydraulic engine that starts the engine rotation
AB RESET - inop
MAX POWER - inop