User manual
Table Of Contents
- 1: Cover
- 2: Cover Back
- 3: Introduction
- 4: Development Team
- 5: Installation
- 6: Configuration
- 7: Menus
- 8: Operation Mode
- 9: Initiation Mode
- 10: Controls
- 11: Effects Lighting and Sounds
- 12: Effects Vibrations
- 13: Preflight
- 14: Ground Equipment
- 15: Walkaround Check
- 16: Trimtabs
- 17: Oil Liquids
- 18: Payload
- 19: Maintenance
- 20: Equipment
- 21: Workshop
- 22: Service
- 23: Instructor
- 24: Instructor General
- 25: Engine and Liquids
- 26: Fuel System
- 27: Electrical System
- 28: Handling
- 29: Handling Concepts
- 30: Handling Concepts
Neither the software nor the documentation may
be used for real aviation and training purposes.
01<11
page
DA20-100 ‘Katana’ 4X Manual
1.5.2
SETTINGS INITIATION MODE
As soon as the Katana has been loaded, the
add-on tries to figure out the situation of the
aircraft to configure itself. This mechanism can
be overriden by selecting Cold and Dark or
Parked.
The aircraft is ready to power up the systems
and start the engine. It is advised to perform
the walkaround check anyway.
Cold and Dark
Parked
The aircraft has been parked for a while so
you should check carefully all the systems
and prepare the aircraft for the flight.
The aircraft shall be set into the appropriate
condition. If it is not able to figure out ist
situation, it will be forced into a status with
engine and all systems running.
Automatic
AUTOMATIC
Aircraft tries to figure out the
situation of flight and configures
iteslf.
Aircraft is forced in ‘cold and dark’
status after loading.
COLD AND DARK
Aircraft is forced in ‘parked’
status after loading.
PARKED
INITIATION MODE
INTRODUCTION AND DESCRIPTION