User manual
Table Of Contents
- 1: Cover
- 2: Cover Back
- 3: Introduction
- 4: Development Team
- 5: Installation
- 6: Configuration
- 7: Menus
- 8: Operation Mode
- 9: Initiation Mode
- 10: Controls
- 11: Effects Lighting and Sounds
- 12: Effects Vibrations
- 13: Preflight
- 14: Ground Equipment
- 15: Walkaround Check
- 16: Trimtabs
- 17: Oil Liquids
- 18: Payload
- 19: Maintenance
- 20: Equipment
- 21: Workshop
- 22: Service
- 23: Instructor
- 24: Instructor General
- 25: Engine and Liquids
- 26: Fuel System
- 27: Electrical System
- 28: Handling
- 29: Handling Concepts
- 30: Handling Concepts
DA20-100 ‘Katana’ 4X Manual
1.6.8
PREFLIGHT - PAYLOAD
Neither the software nor the documentation may
be used for real aviation and training purposes.
01<20
page
The Payload window is used to adjust the weights of the two pilots and their
baggage. Each weight can be easily adjusted with the +/- buttons. The
person or the baggage can be loaded or unloaded with a right click. The
pilot will automatically be loaded if the aircraft is getting prepared for flight.
1.6.9
PREFLIGHT - CLEANING
Use the water faucet to fill the bucket.
1
1
2
3
4 5
Pull the bucket to the aircraft and below the sponge.
2
Move the sponge down into the bucket until it is full of water. Pull it up again.
3
As long as the sponge is wet, wipe with the mouse over the areas you want to
clean. Some sorts of dirt need more work than others. For example oil is far more
difficult to remove than insects and mud.
4
Turn on the vaccum cleaner and move the mouse around in the cockpit to remove
dirt in the cabin.
5
INTRODUCTION AND DESCRIPTION