User manual

10 11
English
Bonaire Flamingo Airport X
Aerosoft GmbH 2015
Airport Data
NAME Flamingo Airport
ICAO TNCB
IATA BON
Lat N 12 07 50.91
Long W 068 16 02.71
ELEV 24‘ / 7.4mm
Runway 10/28 9,449‘ / 2,880m
Frequencies
FLAMINGO TOWER 118.7
HATO APPROACH 119.6
CURAÇAO CONTROL 124.1/127.1
Navaids
BONAIRE NDB 321 KHz PJB
HATO TACAN 134.10MHz HTO
CURAÇAO VOR-DME 116.70MHz PJG
PUNTA SAN JUAN VOR-DME 112.90MHz VSJ
CORO VOR-DME 117.30MHz CRO
GRAN ROQUE VOR-DME 113.10MHz LRS
PUERTO CABELLO VOR-DME 117.70MHz PBL
ARUBA VOR-DME 112.50MHz ABA
Config tool
This scenery includes a configuration tool. The tool is designed to
let the end user adjust the level of detail in the scenery to there
preference. This part of the manual explains the different options you
have available.
Model details
This option adjusts the amount of details on some models in the
scenery. Selecting a lower option well result in fewer trees, grass,
bushes and surrounding buildings being shown in the simulator.
Animations
This option adjusts the number of animations in the scenery. Selecting
a lower option will remove wind animations on palm trees and flags
around the terminal.
Texture options
Since Microsoft Flight Simulator X and Lockheed Martin P3D is a 32-bit
software the amount of memory these programs are able to use are
limited. Therefore users who have a lot of add-ons installed can run
into issues with OOM (Out of memory errors).
Bonaire gives you the option to customize the size of almost all the
Bonaire textures being loaded into the simulator, this way you can
tailor the memory load of the airport to match your setup.
You have 3 options to choose from LOW, HIGH, ULTRA.
To make sure the textures are displayed properly in the simulator
Microsoft Flight Simulator X users must make sure they have
TEXTURE_MAX_LOAD edit in the fsx.cfg file.