Thrust Lever Setup

Aerosoft

Airbus A318/A319

FSX Thrust Lever Setup

(only in case you have issues!)

Vol

07-01-8

12 September 2014

Please go through each and every controller you have attached to your system in the FSX controller menu and verify

that all axes for the various controllers are setup correctly, and more important, that there are no double assignments,

like “ENGINE 1 THROTTLE SET” assigned to both Your Throttle quadrant and Pedals.

If more than one hardware axis is setup for the same engine in FSX, the throttle(s) will simply NOT work with the Airbus.

We have seen quite a few customers where this had happened.

After assigning the various controllers and their axes, you should

close down FSX and restart it, otherwise the new settings might not

be saved correctly.

USING FSUIPC WITH AXES NOT ASSIGNED IN FSXCONTROLLER MENU

We have seen a lot of users who define the axes not via the standard FSX routines but via FSUIPC. Often this is simply

not needed!

You do NOT need FSUIPC for the Aerosoft Airbus models, you will

only need FSX.

If using you are using FSUIPC assignment, make sure that the throttles are not assigned in the FSX controller menu.

Open the FSUIPC menu and go to Axis assignment and set a checkmark in Aircraft specific? Checkbox.

Setup each throttle axis to read like this: