Thrust Lever Setup

A318/A319/A320/A321

Professional

P3D Thrust Lever Setup

(only in case you have issues!)

Vol

07-03-8

10 July 2018

Please go through each and every controller you have attached to your system in the P3D controller menu

and verify that all axes for the various controllers are setup correctly, and more important, that there are no

double assignments, like “ENGINE 1 THROTTLE SET” assigned to both Your Throttle quadrant and Pedals.

If more than one hardware axis is setup for the same engine in P3D, the throttle(s) will simply NOT work

with the Airbus. We have seen quite a few customers where this had happened.

After assigning the various controllers and their axes, you

should close down P3D and restart it, otherwise the new

settings might not be saved correctly.

USING FSUIPC WITH AXES NOT ASSIGNED IN P3DCONTROLLER MENU

We have seen a lot of users who define the axes not via the standard P3D routines but via FSUIPC. Often this

is simply not needed!

You do NOT need FSUIPC for the Aerosoft Airbus models,

you will only need P3D.

If using you are using FSUIPC assignment, make sure that the throttles are not assigned in the P3D controller

menu. Open the FSUIPC menu and go to Axis assignment and set a checkmark in Aircraft specific? Checkbox.

Setup each throttle axis to read like this: