Volume 7: Thrust Lever Setup Record of revisions revision n° 001 Issue date Release Description 15 June, 2018 1.
A318/A319/A320/A321 Professional P3D Thrust Lever Setup (only in case you have issues!) Vol 7 07-03-2 10 July 2018 INTRODUCTION Please note we show FSX dialog here, but they are virtually identical in P3D. STOP, if you have no problems with the throttles in the Aerosoft A318/A319/A320/A321/A330, stop reading and go and fly. This document is really only needed for people whose setup is none standard.
A318/A319/A320/A321 Professional P3D Thrust Lever Setup (only in case you have issues!) Vol 7 07-03-3 10 July 2018 buttons are shown. You can test but it is better to calibrate. Select Settings/Calibrate and follow the instructions. Take your time, this really is important. If you ever have problems again, always calibrate first before doing anything else! CHECK THE CONFIGURATION The next thing we are going to check is the setting in the configuration files of the Aerosoft Airbus.
A318/A319/A320/A321 Professional P3D Thrust Lever Setup (only in case you have issues!) Vol 7 07-03-4 10 July 2018 SETTINGS INSIDE P3D Go slow, make sure you check the images thoroughly so you do not miss any of the settings! In P3D select “Settings”, then “Controls…”. We’ll look at the CALIBRATION tab first Note that preferably the Null Zones should be set to minimum and Sensitivity set to Maximum. Now click the CONTROL AXES tab.
A318/A319/A320/A321 Professional P3D Thrust Lever Setup (only in case you have issues!) Vol 7 07-03-5 10 July 2018 If you got an advanced setup with joystick/yoke, throttle quadrant and pedals, then it could look like this:
A318/A319/A320/A321 Professional P3D Thrust Lever Setup (only in case you have issues!) Vol 7 07-03-6 10 July 2018
A318/A319/A320/A321 Professional P3D Thrust Lever Setup (only in case you have issues!) Vol 7 07-03-7 10 July 2018
A318/A319/A320/A321 Professional P3D Thrust Lever Setup (only in case you have issues!) Vol 7 07-03-8 10 July 2018 Please go through each and every controller you have attached to your system in the P3D controller menu and verify that all axes for the various controllers are setup correctly, and more important, that there are no double assignments, like “ENGINE 1 THROTTLE SET” assigned to both Your Throttle quadrant and Pedals.
A318/A319/A320/A321 Professional P3D Thrust Lever Setup (only in case you have issues!) Vol 7 07-03-9 10 July 2018 Then select the Joystick calibration tab and check it look like this: You will need to repeat this for each of the Airbus models you fly. With the above setup you won´t have reverse thrust with your hardware levers, but will need to use F2 to engage revers thrust. Another solution can be found here: http://forum.aerosoft.com/index.