Step by Step Guide

A318/319/320/321
Profesional
Step-By-Step Tutorial
Vol
6
06-01- 46
11. Dezember 2018
Taxichart EDDF B47 to Runway 18
5.10 Before Takeoff
BEFORE TAKEOFF
NO.
PANEL
ACTION
REMARK
TYP
PART (Name)
PART (No.)
PF (PILOT FLYING)
PM (PILOT MONITORING)
152
INFORMATION TO CABIN CREW
“Please prepare for Takeoff”
153
OVERHEAD
EXT. LIGHTS
9
TAXI TO RUNWAY HOLDING POINT
Start Checklist / Co-Pilot please see below
154
ECAM
WHEEL PAGE
1
BRAKE TEMP = below 150
CHECK
Cop
CoP set Brake Fans On if Brake Temp >150
155
MAIN PANEL
BRAKE FAN
11
BRAKE FANS
OFF
Cop
156
PEDESTAL
ENGINE
5
ENG MODE SEL = NORMAL
CHECK
157
PEDESTAL
TCAS
10
TCAS TA/RA plus TILT ABOVE
SET
CoP
158
OVERHEAD
EXT. LIGHTS
9
EXT. LIGHTS
SET
CoP
Strobes (ON), Land. (ON) and Nose Lights (TO)
159
PF SLIDING TABLE
STOWED
Cop
Checklist complete
160
PEDESTAL
WXR
11
TILT: UP and select 4 degrees up
SET
161
MAIN PANEL
N/SKID NW
10
A/SKID & NW STRG
CHECK = ON
162
PEDESTAL
RADIO
1
TAKEOFF / LINE UP CLEAR
OBTAIN
If ATC is used
163
PEDESTAL
RADIO
1
ATC (if no AUTO position)
ON
If ATC is used
143.
Start Before Takeoff CL: After the TAXI CL has been finished a message on the INFOBAR will pop up
displaying the options to manually start the checklist.
• You can start the CL manually using the 2D MCDU CHECKLIST menu option
• Just use “1” on the keyboard
For several reasons the automatic start of this checklist has been removed completely.
144.
Brake Temperature: BRAKE TOO HOT: Values to trigger this are 150/100°. Before Takeoff CL also
accepts brake temperature of >150° and proceeds if brake fans are ON.
145.
TCAS: Use the ring of the knob to set the mode to TA/RA. But below 1000 ft the ND will display TA
ONLY.
146.
Ext. Lights: STROBE=ON – BEACON=ON – WING=OFF – NAV&LOGO=2 – RWY TURN OFF=ON – LAND=
ON – NOSE = TO. If light is OFF the copilot sets the switch to ON.