Step by Step Guide

A318/319/320/321
Profesional
Step-By-Step Tutorial
Vol
6
06-01- 45
11. Dezember 2018
149
PEDESTAL
WXR
11
SET system to 1 (ON) and knob to WX-T
SET
CoP
Checklist complete
150
EFIS
FD / ILS
3
FD
CHECK ON
151
PEDESTAL
TRANSPOND.
9
ATC CODE
CONFIRM / SET
If ATC is used
48.
THRUST LEVERS: Set thrust levers to the manual range. Around 35 % N1 (EWD) should be enough to
start the aircraft moving. Then set the thrust levers back to ZERO. Taxiing should be operated at 20
knots, with 10 knots during turns. If you are getting too fast just use the brakes to reduce speed.
49.
BRAKES: Just use the brakes for a moment.
50.
Takeoff Data: Check data (– V1 – VR – V2 – Flaps – Flex Temperature – Destination Fuel on Board –)
which are available on the PERF TAKEOFF as well FUEL PRED page.
140.
Altitude: The FCU ALT target value will be entered by the copilot in visible steps (with sound) and also
considering the 100 and 1000 switch.
141.
ECAM PANEL – TO CONFIG: Just push the button on the ECAM panel.
142.
WXR: Set the main switch to 1 (ON) and the WXR knob to WX-T. More information you will find in
chapter 2.1.3.