Step by Step Guide

A318/319/320/321
Profesional
Step-By-Step Tutorial
Vol
6
06-01- 99
11. Dezember 2018
that it is never less than VLS + 5 or more than VLS +15. As a result, VAPP is increased above its
minimum value for runway headwinds above 15 knots. VAPP correction is not increased further for
headwinds exceeding 45 knots. No additions are made for gusts.
61.
Glideslope “alive”: When the Localizer has been captured (please see picture #70 above) soon after
the vertical glide slope becomes “alive” (magenta rhombus fully appears) which will be confirmed by
a call.
62.
Glideslope “captured”: When the glideslope has been captured it will be confirmed by a call.
The middle of both PFD fields shows the vertical and lateral position of the aircraft where as the
magenta rhombus shows the actual position on the glide path. This means that during the approach
both rhombuses are moving to the center. On the EFIS control panel please change the knob for the
various views to LS. This view also shows the glide path and the position of the aircraft to it.
G/S captured – LS view
66.
Auto Throttle: Leave the A/THR on…..
67.
Wing Anti Ice: Leave the Wing Anti Ice OFF
8.11 Landing
LANDING
NO.
PANEL
ACTION
REMARK
TYP
PART (Name)
PART (No.)
PF (PILOT FLYING)
PM (PILOT MONITORING)
68
Flaps in Landing Config. (MCDU Settings)
Start next Checklist / Co-Pilot - if selected
69
MAIN PANEL
GEAR
7
LAND. GEAR = FULL EXTRACTED
CHECK
CoP
70
PEDESTAL
SP. BRAKEs
6
GROUND SPOILERS = FULL
CHECK
CoP
P3D: Right mouse click
71
MAIN PANEL
AUTO BRAKE
6
AUTO BRAKES = MEDIUM
SET
CoP
72
OVERHEAD
EXT. LIGHTS
9
NOSE = TO or TAXI / LANDING L. = ON
CHECK
CoP
73
FCU
ALT
3
GO AROUND ALT
CHECK
CoP
74
BEFORE OR AT DECISION ALTITUDE
75
FCU
AP
5
AP
OFF
CoP
P3D: Z
76
CALL: STANDBY – STANDBY - FLARE
77
At 60 feet: (PM CALL = FLARE”)
78
FLARE
PERFORM
79
PEDESTAL
THR LEVER
4
THRUST LEVERS
IDLE
P3D: F1
80
At touchdown:
81
PEDESTAL
THR LEVER
4
REV
MAX
P3D: F2
82
BRAKES
AS REQUIRED
83
At 70 knots:
84
PEDESTAL
THR LEVER
4
REV
IDLE
P3D: F1
85
At taxi speed:
86
PEDESTAL
THR LEVER
4
REV
STOW
CoP
87
Before 30 knots:
88
MAIN PANEL
AUTO BRAKE
6
AUTOBRK
DISENGAGE
CoP
Checklist complete
70.
Ground Spoilers: Speed Brakes should already be set to FULL (see #55)
71.
Auto Brake: Set to MED (medium)
72.
Exterior Lights: Just check if all Exterior Lights are on: Strobe, Beacon, Nav & Logo as well as Landing
Lights.