Manualshelf

Normal Procedures

ManualsBrandsAerosoft Sim-Wings ManualsApplicationsAirbus A318 A319 A320 A321 Professional
21222324252627282930
A318/A319/A320/A321
Professional
Normal Procedure Guide
02-01-22
10 July 2018
TAXI LIGHTS and TURN OFF LIGHTS ............................................................... CHECK ON PF/PM
FLAPS 3 /FULL ............................................................................................... SELECT PF/PM
• PF call “Flaps 3” (or “Flaps full). PM checks flap extension conditions,
answers “Flaps 3(full)” and moves flaps lever to 3 (full). When flaps indication
shows the flaps are extended PM will announce “Flaps 3 (full) green”.
Monitor deceleration towards VAPP. Speed brakes should be retracted
before flaps 3 or flaps full extension. FLAPS FULL must be used in possible
wind shear conditions or turbulence.
GROUND SPOILERS........................................................................................ ARM PF
A/THR ........................................................................................................... CHECK PF
• Verify that A/THR mode (SPEED or OFF) and TARGET SPEED are in
agreements with intentions.
GO AROUND ALT ........................................................................................... SET PF
• The GA altitude is set on FCU when G/S or FINAL APP is green or aircraft
altitude is lower than Go Around altitude
FINAL CHECKLIST ........................................................................................... COMPLETE PF/PM
AT “RETARD RETARD” CALL
THROTTLE ..................................................................................................... TO IDLE PF
FLARE ............................................................................................................ PERFORM PF
LANDING ROLL
DIRECTIONAL CONTROL ................................................................................ MAINTAIN PF
• Use rudder pedals down to 30 kts.
BRAKES ......................................................................................................... AS RQRD PF
• When autobrake is used monitor deceleration.
THRUST LEVERS ............................................................................................. REVERSE PF
• PF applies reverse thrust to decelerate to 70 knots. PM calls “70 knots”.
THRUST LEVERS ............................................................................................. .REV IDLE PF
• PF smoothly reduces reverse thrust to reverse idle.
THRUST LEVERS ............................................................................................. .FWD IDLE PF
• PF sets thrust levers to forward idle when taxi speed is reached.
PM will call “Reverse out” when REV indication disappears.