Manualshelf

Normal Procedures

ManualsBrandsAerosoft Sim-Wings ManualsApplicationsAirbus A318 A319 A320 A321 Professional
11121314151617181920
A318/A319/A320/A321
Professional
Normal Procedure Guide
02-01-15
10 July 2018
AFTER TAKE OFF
APU BLEED .................................................................................................... OFF PM
• If the APU has been used to supply air conditioning during takeoff
select APU BLEED to OFF. APU BLEED is not usable over 15,000 ft maximum.
APU MASTER ................................................................................................. AS RQRD PM
ENG MODE SELECTOR ................................................................................... AS RQRD PM
• Set IGN in heavy rain or heavy turbulence.
ANTI ICE PROTECTION ................................................................................... AS RQRD PF
• When ice conditions are expected or ICE DETECTED is shown on ECAM PF
needs to activate the anti ice systems. Please note that ENG ANTI ICE will
force the FADEC to switch ENG MODE to continuous ignition.
SEAT BELTS .................................................................................................... AR RQRD PF
BARO REF ...................................................................................................... SET/X-CK PF/PM
• At transition altitude (indicated by baro setting flashing on PFD) the PM
calls “Transition altitude”.
• PF calls “SET STD, cross check at FL***”
• PF will call “Top” at FL*** and PM will crosscheck and confirms with “Checked”
AFTER TAKE OFF CHECKLIST .......................................................................... COMPLETE PM
• Checked by PM silently and without cross check from PF with the Altimeter line.
PF will respond with altimeter setting on PFD.
1. Engine Mode Selector ...................... AS RQRD PM
2. Spoilers ........................................... DISARMED PM
3. Flaps ................................................ RETRACTED PM
4. Landing Gear ................................... UP/LTS OUT PM
5. Exterior Lights .................................. RET/OUT PM
6. Packs ............................................... ON PM
7. Altimeter ......................................... STD PF/PM