User guide

Page | 13
MRK-D-0022 V3.1 Aeroqual Series 200, 300 & 500 User Guide
3.4.9. Control Points (Series 300 & 500)
 The control points can be found under “MONITOR SETUP”, scroll down in the monitor set up
menu and select “CONTROL POINTS”
 Once the control points set up menu has been entered “CONTROL HI” will display
 Press the “scroll up” and “scroll down” buttons to select the correct concentration
 Press “enter” to confirm the change
 Once the high point has been set “CONTROL LO” will display
 Press the “scroll up” and “scroll down” buttons to select the correct concentration
 Press “enter” to confirm the change
3.4.10. Clock Setup (Series 500)
 The clock setup can be found under “MONITOR SETUP”, scroll down in the monitor set up
menu and select “CLOCK SETUP”
 To change the hours press the “scroll up” and “scroll down” buttons until correct time is
recorded
 Press “enter” to confirm and adjust the minutes using the “scroll up” and “scroll down” buttons.
 Repeat to adjust the seconds, month, day and year.
Note: The clock is a 24 hour clock
3.4.11. Logging Setup (Series 500)
 To enter, scroll down in the set up menu and select “LOGGING SETUP”
 The log frequency will appear on the display.
 Adjust the frequency by using the “scroll up” and “scroll down” buttons
Note 1: The frequency is set to 1 minute intervals
 Once the frequency is set, press the “enter” button to confirm.
 The option to clear the log will then display on the screen.
 Press the “scroll up” button to select either YES or NO and press “enter” to confirm the
selection.
Note 2: The data log can also be cleared directly from the main display screen by holding
down the mute button for 2 seconds until the monitor beeps (if the monitor keys are not
muted).
Month: Day: Year
Hours: Minutes: Seconds
14:30:12
Oct 07 12