User guide

Page | 11
MRK-D-0022 V3.1 Aeroqual Series 200, 300 & 500 User Guide
Note 1: The MIN, MAX and AVE readings are the minimum, maximum and average readings
over the period from the start of the cycle.
Note 2: The RD value is the current reading.
Note 3: The speed of the display scrolling is dictated by the slowest sensor. The display will
scroll every time a new set of readings have been taken.
3.4.3. Calibration
To enter, scroll down in the set up menu and select either “ZERO CAL” on the Series 200 or
“CALIBRATE” on the Series 300 and 500. To enter the calibrate menu the “mute” and “scroll
down” button needs to be held down for 2 seconds. From here either “ZERO CAL” or “SPAN
CAL” can be selected.
For more information on how to calibrate the sensor heads please refer to Section 6 of the User
Guide.
3.4.4. Mute Key
 To mute the audible feedback “beeps” that occur when you press a button, scroll down in the
set up menu and select “MUTE KEY”. (Found under “MONITOR SETUP” in the Series 300
and 500)
 Press the enter key to silence the audible feedback “beeps”, the word muted will appear next
to MUTE KEY
 On the Series 200, if the device is turned off the mute settings will be returned to the default
state and will have to be reset when the monitor is restarted
3.4.5. Location ID (Series 300 & 500)
 To select the location ID, scroll down in the set up menu and select “LOCATION ID”
 The location ID provides a means of identifying the location where a measurement was taken.
This can be used to quickly trace a measurement back to a location
 Location ID is logged for each measurement
 Press “enter” to confirm the ID and return to the set up menu
3.4.6. Monitor ID (Series 300 & 500)
 The monitor ID can be found under “MONITOR SETUP”, scroll down in the monitor set up
menu and select “MONITOR ID”
 Each monitor can be numbered to identify them quickly when more than one is in use
 Data is tagged with the monitor ID at the time it is downloaded to the PC, so you can use
more than one monitor with a single instance of PC software (S500 only). Each record in the
database contains date/time, monitor id, location id, sensor type, sensor reading.