User guide

Page | 10
MRK-D-0022 V3.1 Aeroqual Series 200, 300 & 500 User Guide
Series 200 Series 300 Series 500
3.4.1. Units
 To enter, scroll down in the set up menu and select “UNITS”. (Found under “MONITOR
SETUP” in the Series 300 and 500)
 Choose between ppm or mg/m
3
via the scroll button and press enter to confirm the unit
selection
 If there is a temperature and humidity sensor attached there is the option to choose from
either °C or °F
3.4.2. Max/Min/Average Measurement Cycle
 To enter, scroll down in the set up menu and select “MAX MIN AV”
 Select “start” to initiate the measurement cycle and return to the setup menu
 Scroll to “EXIT” to return to the main display
 The readings will scroll along the screen
Note: Only three parameters will be shown on the screen at one time.
 In the Series 300 and 500 the “MAX MIN AV” cycle can also be initiated from the main display
by holding down the “scroll down” button for 2 seconds until the unit beeps. Hold down the
“scroll down” button again for 2 seconds to stop the measurement cycle.
 When the “MAX MIN AV” cycle is initiated, the display should read as seen below:
or
EXIT
LOCATION ID
MAX MIN AV
CALIBRATE
MONITOR SET UP
EXIT
LOCATION ID
MAX MIN AV
CALIBRATE
MONITOR SETUP
LOGGING SETUP
EXIT
ZERO CAL
UNITS
MIN MAX AV
MUTE KEY
O3 UL
PPM
RD 0.010
MIN 0.005
MAX 0.024
AVE 0.015
O3 UL TEMP RH
PPM C %
RD 0.010 23 50
MIN 0.005 22 50
MAX 0.024 25 56
AVE 0.015 24 54
EXIT
MONITOR ID
UNITS
OUTPUT SENSOR
ALARM POINTS
CONTROL POINTS
MUTE KEY
EXIT
MONITOR ID
UNITS
OUTPUT SENSOR
ALARM POINTS
CONTROL POINTS
MUTE KEY
CLOCK SETUP