User's Guide

Form #: OP_01_TM
Title: Aeronix Data Links – EDL Nano Products User Guide
Document Number: AE301628-001
Revision: B Date: 3 October 2019
Aeronix Proprietary
73
Table 3-20. Subscriber Station Radio Control
Field/Control
Description
connected to the first base station a
successful connection is made
 Current Channel – Displays the current
channel and frequency of the base station.
 Channel (Freq) – – Pull down menu to
choose a different channel/frequency for
the base station. The base station and
subscriber stations need to be configured
for the same channelization for proper
operation.
 Set Button – Changes the current channel
of the base station to the channel selected
by the channel (freq) drop down.
 Custom Freq (2412 – 2462) – Allows user
to create a frequency outside of the drop
down frequency list. The frequency must
be a valid operating frequency for the unit.
 Set Button – Changes the current channel
of the base station to the custom
frequency
 Current Channelization – Displays the
current channelization of the radio. The
base station and subscriber stations need
to be configured for the same
channelization.
 Channelization Selection – Allows the
selection of the channelization. Current
choices are 3.5 MHz, 7 MHz, and 14 MHz
 Set Button – Changes the current
channelization selected by the user.
Note: Selecting a frequency outside of the
ISM band (2400 – 2483.5MHz) voids the
FCC Part 15.247 Certification.
5
Power Values
 BS Estimated EIRP - Displays the
estimated EIRP of the base station based
upon user configured gain and loss
values.
5A
Power output mode
OFDM only
 High Power – radios TX power is
calibrated to a higher power that still has a
good enough EVM to maintain the QAM16
modulations. The QAM64 modulations will
be disabled, if user re-enables them there
is no guarantee the signal quality level will
sustain QAM64
 High Data – radios will TX power will be
set to a power level whose EVM will