User's Guide

Form #: OP_01_TM

Title: Aeronix Data Links – EDL Nano Products User Guide

Document Number: AE301628-001

Revision: B Date: 3 October 2019

Aeronix Proprietary

3.6.3.7. Base Station Network Config Class Rules

If user is not using the ARP Table feature, then they will need to configure classifiers for IP data

to pass between the radios. The Classifier Status must be enabled in the Network Options section

of the Network Config page.

The class rules define the paths that are valid for data transmission within the network. It is valid

to define class rules by using IP addresses or MAC addresses. All class rules must be defined

using the same address type. Class Rules are configured on the base station and transferred to

the subscribers when they connect to the base station. A valid class rule must exist for each

downstream service flow and for each upstream service flow for data to pass in the define

direction.

Figure 3-22 BS Network Config Class Rules

Table 3-9. Base Station Network Config Service Class

Field/Control

Description

Current Class Rules

Mode

 Address Mode - Displays the current

address mode for the class rules. The

valid values are IP and MAC

 Forwarders Enabled - If selected, the GUI

will populate forwarders for each

configured SS. Auto populate does not

account for multiple service flows per

subscriber. The additional class rules

need to be entered manually.

 Non-Forwarder Count - Indicates the

number of class rules not using

forwarders.