User's Guide

ManualsBrandsAeronix ManualsElectronicsLOW POWER ISM BAND TRANSCEIVER

Form #: OP_01_TM

Title: Aeronix Data Links – EDL Nano Products User Guide

Document Number: AE301628-001

Revision: B Date: 3 October 2019

Aeronix Proprietary

Table 3-5. BS Admin Start Script and S/W Update

Field/Control

Description

 IPv4 Address: Provides the capability to set a

new IPv4 address for the unit.

 IPv4 Netmask: Provides the capability to set a

new IPv4 netmask address for the unit

 IPv4 Default Gate (Opt) : Optional ability to

configure an IPv4 default gateway.

 Vlan ID (Optional) : Allows user to add a VLAN

ID to IP packets coming from radio. The radio

will pass VLAN tagged packets unmodified, so

this does not need to be set to allow VLAN

packets to flow through the radio. Only if

communication to the radio needs to have a

VLAN ID.

 IPv6 Default Gate (Opt) : Optional ability to

configure an IPv6 default gateway.

 IPv6 Address (Optional) : Optional IPv6 address

for the Ethernet (Note : current release of EDL

does not support IPv6)

 IPv6 Netmask (Optional) : Optional IPv6

netmask for IPv6 address (Note: current release

of EDL does not support IPv6)

 Generate Script Button : Generates a new start

script for the unit with the values input in the

“Generate Bridging Start Script” section of the

Admin page. Once the script has been

generated, the unit must be rebooted or power

cycled for the new values to take effect. The

unit should not be power cycled while script

generation is in process.

Software Update

Allows user to select a signed package file provided by

the manufacturer to update the software on the unit.

 File Path – Allows users to browse to location

where the package file resides.

 Start Update - Selection of the start update

button starts the software update using the

factory signed package file specified in the File

Path. Once the update process begins, any

interruption can render the box unusable and

require its return to the factory.

3.6.2.3. Example Adding a SS Entry

A subscriber must be added here in order to continue configuring that subscriber in network.

Enter a name for the subscriber and then a IEEE 802.16 MAC address for the subscriber station. The

MAC address should be of the format 00-61-65-6E-64-XX where XX is the subscriber number in the

system. The subscriber number is configured in the start script as part of the subscriber start script

generation which is described later in this section of the document.