User's Guide

Form #: OP_01_TM
Title: Aeronix Data Links – EDL Nano Products User Guide
Document Number: AE301628-001
Revision: B Date: 3 October 2019
Aeronix Proprietary
123
Note: If the Classifier Status and ARP Table Status are both enabled, the software will search the
ARP table first for a match, if no match is found then the classifier table will be searched.
7.3. Aeronix Serial Flow Control Feature
The Aeronix serial flow control feature allows serial data to pass through the NANO’s Platform
RS-232 interface (See Table 2-8. J1: Main IF Pin Definitions ). This section will go into further
detail on how to setup the Serial B to Serial B Flow Control.
The transmitted serial data is wrapped in a UDP packet and configured with the Destination IP
address for the radio the serial data is intended for and a user configured destination port ID. The
example below show the BS connected to a GPS serial receiver via the radios platform serial
interface. SS1 has a laptop connected to its platform serial interface with a console display. The
BS will packetize all data from its RS-232 serial interface and send it over the RF destined for
SS1. SS1 will push any data it receives containing destination IP address of its radio and a
destination port address matching the “Receive port” of the serial flow control, to its serial
device.