User's Guide

Form #: OP_01_TM
Title: Aeronix Data Links – EDL Nano Products User Guide
Document Number: AE301628-001
Revision: B Date: 3 October 2019
Aeronix Proprietary
108
9) Once the ‘Generate Script’ button is selected, the old start script will be overwritten with
the new start script changes. Once a reboot or power cycle occurs the new changes will
take effect.
6. Adding Subscriber example using webgui
This example shows the method for adding a third subscriber to the base station configuration.
This example assumes that the radios are configured in bridging mode with IP classifiers and no
forwarding classifiers configured. It also assumes the use of preexisting service classes. The
picture below shows the physical configuration.
Figure 6-1 Example Adding Subscriber Layout
Adding a subscriber to the Station Names table:
1. Browse to the Admin page of the base station.
2. Click on the ADD ENTRY button in the Station Names section.
3. Add a name for the subscriber and the appropriate MAC address for subscriber number 3
which is 00-61-65-6E-64-03.
o Note: The MAC Address needed on the Admin for a Subscriber is the Aeronix
MAC address for that subscriber (00-61-65-64-XX where XX is the Subscriber
number).
4. Click on the ADD button to the right of the subscriber entry.
5. The subscriber appears in the station names table as show below.