Instruction manual

8
ASSEMBLY/FUNCTIONAL TEST
1. Connect the Medication Cup to the
Nebulizer Body by lining up the notches
on the medication cup and nebulizer
body.
NOTE: Ensure the Aeroneb Go
handset is not connected to the
controller when adding medication to
the medication cup.
2. Insert the nebulizer cable into the back of
the nebulizer unit.
3. Add Aeroneb
®
Go base to the bottom of
the handset.
4. Fill the Medication Cup with the
prescribed nebulizer medication. Never
pour more than 6 mL into the cup. The
continuous line on the inside surface of
the cup indicates the maximum lling
level. CAUTION: To avoid damage
to the nebulizer unit, do not use a
syringe with needle.
5. Place the Cap on Medication Cup.
6. Attach Mouthpiece or Mask Connector
and mask to Nebulizer Body.