User's Manual

Chapter 8 HiveManager Configuration Examples
128 Aerohive
WLANpolicy-hq1 (Page 2)
On the second page of the new WLAN policy dialog box, you can map SSIDs to management service filters, AAA
servers, radio modes, and user profiles. In addition, you can set the Ethernet interface in access mode
(Bridge-Access or Bridge-802.1Q) and assign management service filters to the Ethernet and wireless backhaul
interfaces. (Note that because no management service filters were set in the previous examples, you only configure
WLAN mappings below.) See Figure 18.
Figure 18 Second Page of the WLAN Policy Dialog Box
WLAN Mappings
Configure the WLAN mappings of SSIDs to radio modes and user profiles. (The SSIDs were previously configured
in "Example 5: Setting SSIDs" on page 117, and the user profiles were configured in "Example 4: Creating User
Profiles" on page 113.)
SSID: voip
1. Enter the following to define the WLAN mappings for the voip SSID, and then click Apply:
• SSID Profile: voip
•MGT Service Filter: def-service-filter (default)
• AAA Servers: (leave empty; this setting is for overriding the RADIUS server setting on the previous page
of this dialog box, and, in any case, is not applicable to SSIDs using preshared keys)