User's Manual
Aerohive BR200-LTE-VZ routers allow enterprises to provision branch office networks and teleworkers
quickly and easily. The BR200-LTE-VZ router provides LAN and WLAN connectivity and PoE (power over
Ethernet) support.
The BR200-LTE-VZ router has a single dual band 2.4/5 GHz (802.11b/g/n) radio, an embedded
LTEmodem for use with the Verizon 4G LTEnetwork, two external embedded antennas with diversity,
one WAN port (ETH0), four LAN ports (ETH1 through ETH4), a Console port, and an LTE USB port for WAN
connection redundancy. BR200-LTE-VZ routers support up to 16 SSIDs, 16 VLANs, 16 networks, and 64
user profiles across both wired and wireless interfaces.
• For more information about Aerohive routers in general, see "Introduction to Aerohive Routers"
• For more information about how to configure your router, see "Routing Configuration".
Installing Aerohive BR200-LTE-VZ Routers
You can install the BR200-LTE-VZ router on a desktop or mount it on a wall using the wall mount keyholes
on the bottom of the device. To mount the device on a wall, first install two drywall screws 5.875" (14.92
cm) apart in the wall. The heads of the screws must not be wider than 0.25" (0.64 cm) so that they will
fit inside the openings in the keyholes. Place the wide section of keyholes over the screws and press the
device down to secure it to the wall.
Hardware Components
You can see the hardware components for theBR200-LTE-VZrouter in the following illustration, and read
about them in the descriptions that follow.
To meet federal radiation exposure requirements, these devices should be installed at a
minimum distance of 9.05" (23 cm) from your body.
Graphic still under construction
Component Descriptions
• Radios:
One 3x3:3 2.4/5 GHz radio (802.11b/g/n)
One 2x2 MIMO LTEradio with global fallback to CDMA/HSPA+/UMTS
• Antennas:
Page 2 of 7BR200-WP and BR200 Routers
5
/
14
/
201
4
file:///C:/Users/dknodel/AppData/Local/Temp/MC_.ht
m
Preliminary Draft