User's Manual

無線資訊傳設備的製造廠商應確保

頻

率穩定性，如依製造廠商使用手冊上所述正常操作，發射的信號應維持

於操作頻帶中。

Taiwan MPE Warning

電磁波曝露量MPE標準值(MPE) 1mW/cm2，送測產品實值為0.734 mW/cm2

Safety Guidelines

The information in this section applies to AP550 devices. The following safety icons identify the type

of precaution:

This icon indicates a general caution. Failure to comply with a

caution notification can result in damage to equipment.

This icon indicates an electrical caution. Failure to comply with

an electrical notification can result in serious injury or death,

and extensive damage to equipment.

The following table lists the safety precautions you should follow when installing your

AP550.

Aerohive devices must be installed by a professional installer

who is certified to install these types of devices and to ensure

that they are properly grounded and meet applicable local

and national electrical codes.

These devices are intended for indoor use only.

Do not install the device in an environment where the

operating ambient temperature might exceed the

recommended ranges.

Electrical equipment generates heat. Ambient air temperature

may not be adequate to cool equipment to acceptable

operating temperatures without adequate circulation. Be sure

that the room where you install your device has adequate air

circulation.

Changes or modifications made to this device that are not

expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

Electrostatic discharge (ESD) can damage equipment and

impair electrical circuitry. ESD damage occurs when electronic

components are improperly handled and can result in

complete or intermittent failures. Be sure to follow ESD-

prevention procedures when handling electronic equipment

and components.

Never assume that power is disconnected from a circuit; always

check the circuit.

Page 6 of 1

AP550 Hardware User Guid