User's Manual

2. Install two wall mount screws (and plastic anchors if necessary). Leave the screw
heads far enough away from the wall so that the bracket will slip over the screw heads
(you can test this using the bracket). If you are connecting the device to cables from
inside the wall, drill an access hole for the cables.
3. Attach the device to the bracket by lining up the mount tabs on the bottom of the
device with the corresponding tab depressions on the bracket. Slip the tabs under the
edges of the tab depressions and rotate the device until it clicks into place on the
bracket.
4. Mount the device on the wall or ceiling by slipping the bracket keyholes over the
screw heads and sliding the screws into the narrow part of the keyhole.
To remove the device from the bracket, use a small flat-blade screwdriver or similar tool
to depress the mount clips on the bottom of the device and release it from the bracket,
as shown in the illustration.
Pag
e 8 of 15
Aerohive AP250