User's Manual

This icon indicates an electrical caution. Failure to comply with an
electrical notification can result in serious injury or death, and extensive
damage to equipment.
The following table lists the safety precautions you should follow when installing your
AP250 devices.
Aerohive devices must be installed by a professional installer who is
certified to install these types of devices and to ensure that they are
properly grounded and meet applicable local and national electrical
codes.
These devices are intended for indoor use only.
Do not install the device in an environment where the operating ambient
temperature might exceed the recommended ranges.
Electrical equipment generates heat. Ambient air temperature may not
be adequate to cool equipment to acceptable operating temperatures
without adequate circulation. Be sure that the room where you install
your device has adequate air circulation.
Changes or modifications made to this device that are not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Electrostatic discharge (ESD) can damage equipment and impair
electrical circuitry. ESD damage occurs when electronic components are
improperly handled and can result in complete or intermittent failures. Be
sure to follow ESD-prevention procedures when handling electronic
components.
Make sure the rack or cabinet (if used) housing the device is adequately
secured to prevent it from becoming unstable or falling over.
Never assume that power is disconnected from a circuit; always check
the circuit.
Reliable Grounding - Reliable grounding of rack-mounted equipment
should be maintained. Particular attention should be given to supply
connections other than direct connections to the branch circuit (e.g. use
of power strips.)
To meet radiation exposure requirements in all countries, these devices
should be installed at a minimum distance of 12.5" (32 cm) from your
body. See individual country warning for country-specific distances, if
required.
All Ethernet and RS232 (console) ports and the cables attached to them
are designed for intra-building connection to other equipment. Do not
connect these ports directly to wiring that exits the building where this
appliance is located
Pag
e 6 of 15
Aerohive AP250