User's Manual

Aerohive Networks
4 AP130 User Guide
3. Hold the device upside down and slip the mounting tabs on the bracket over each side of the ceiling
track.
4. Press the device gently against the ceiling track and rotate it until the mount clips click into place.
5. For a square mount, repeat Steps 2 and 3 using the mount tabs and clips on the bottom of the device
(you do not need the bracket).
6. To remove the device, press the mount clips until they disengage form the track, then rotate the device
and pull it away from the track. A flat-blade screwdriver can make it easier to access and press the clips.
Wall Mount
Use the diagonal mounting bracket to attach the AP to any vertical surface that supports its weight, and to
which you can install wall mount screws. To mount the AP130 on a vertical surface, do the following:
1. Use the holes in the mounting bracket as a template to mark the wall for the location of the mounting
screws.
2. Drill two holes that are slightly smaller in diameter than the mounting screws.
3. Install two wall mount screws in the holes. Use screw anchors if necessary.
If you are not installing the device on a concrete wall, you can use threaded screws and plastic wall
anchors (not supplied) to mount the device.
Mount tab
Mount clip
The mount clip
flanges fit under the
inside corners of the
mount clips
Mount tab
Mount clip
Slots for clip
flanges under
corners of
mount clips
Mount tab slo
Mount tab slot
M
M
M
M