Installation Manual
Table Of Contents
- AP1130 Installation Guide
- Kit Contents, Required Accessories, and Tools
- Hardware Components
- Safety Instructions and Site Hazard Warnings
- Installing the AP1130
- Attaching External Antennas
- Setting the Antenna Type
- Attaching the Ethernet Cable Waterproof Housing
- Accessing the Reset Button
- Using the Antenna Alignment Buzzer
- AP1130 LEDs
- Connecting to the Network
- Where to Find More Information
- Federal Communication Commission Interference Statement
- Industry Canada (IC) Statement
Aerohive Networks
6
3. Fit the hose strap around the pole and tighten the clamp with a 1/4” (2 cm) slotted screwdriver or a
5/16” (8 mm) drive socket (or nut) driver.
4. Insert the fifth bolt with washer through the terminal on one end of the ground cable. Thread the bolt
into the ground hole on the back of the unit and tighten it until the ground terminal is secure.
5. Connect the other end of the cable to an appropriate ground.
Correct Alignment of Device to Earth
For both vertical and horizontal installations (such as the arm of a street light), make sure that the face of the
device is perpendicular to Earth for optimal RF coverage and to comply with FCC regulations.
Thread the strap
through the slots in
the mounting bracket
(a vertical pole
mount is shown).
Pole
Tighten the
clamp around
the pole.
Grounding lug
4
5
Grounding nut
Cable terminal
Pole
Earth
Vertical mount Horizontal mount