Installation Manual
Table Of Contents
- AP1130 Installation Guide
- Kit Contents, Required Accessories, and Tools
- Hardware Components
- Safety Instructions and Site Hazard Warnings
- Installing the AP1130
- Attaching External Antennas
- Setting the Antenna Type
- Attaching the Ethernet Cable Waterproof Housing
- Accessing the Reset Button
- Using the Antenna Alignment Buzzer
- AP1130 LEDs
- Connecting to the Network
- Where to Find More Information
- Federal Communication Commission Interference Statement
- Industry Canada (IC) Statement
Aerohive Networks
5
Vertical or Horizontal Pole Mount
The following steps explain how to mount the AP1130 on a vertical or horizontal pole. The pole can be from
1.0 - 2.75 inches (25 to 70 mm) diameter. You can also order a hose strap that will fit poles with a 3" to 15" (76
to 381 mm) diameter (AH-ACC-1130-STRP-3-15).
1. Attach the bracket to the back of the unit for either a vertical or horizontal mount using the four
mounting bolts with attached washers. Tighten the bolts with a crosshead screwdriver. Be sure to use the
bolts with washers from the plastic bag labeled “Pole Mount and Grounding” as they secure the bracket
tightly to the back of the device for pole mounts.
2. Thread the open end of the hose strap through the two tabs on the mounting bracket.
The embossed arrows on the bracket should be pointing up for both a vertical pole mount, and a
vertical surface (wall) mount.
Bracket installed for a vertical pole mount Bracket installed for a horizontal pole mount
Slip large ends of
bracket keyholes over
mounting screws.
Slide bracket up until
screws are in the narrow
portion of the keyhole.
Tighten the locking screws to
secure the bracket.
Locking
screw