User manual

5
5.1.2 Aeroflex Gaisler Board Power
Power to the UT200SpW4RTR-EVB may also be provided from the J9 connector on the GR-CPCI-UT699 LEON3-
FT CPCI Development Board. Jumpers J64 and J65 must be set in order for the 120 pin J63 connector on the 4-Port
EVB to receive power from the LEON-3FT board. J63, the 120 pin connector, is located on the back side of the
UT200SpW4RTR-EVB. Use caution when mating the UT200SpW4RTR-EVB to the LEON-3FT evaluation board. If
the UT200SpW4RTR-EVB will be receiving power from the UT699 Evaluation board, jumpers J57, J58, and J59
should be removed.
NOTE: Only connect jumpers required for the power source in use.
UT200SpW4RTR
4-Port Router
UT54LVDS031LV
Figure 3. Aeroflex Gaisler LEON-3FT Power Jumper Settings